• Power Protect W 30 [eco]
    eco
    Product

    Article No. 026401

    Power Protect W 30 [eco]

    Wedge-shaped insulating board in the Power Protect [eco] system

    Variant
    580 mm x 380 mm (± 2 mm), thickness 30/8 (± 1 mm)
    Variant
    0264 | Power Protect W 30
    Size / Quantity

    Product specifications

    On delivery

    Aw value / water absorption coefficient 41.82 kg/(m²h0.5)
    Reaction to fire B-s1, d0
    Porosity ≤ 94 vol.%
    w80 0.0047 m³/m³
    Water vapour diffusion resistance µ 6.1
    wsat 0.9427 m³/m³
    Thermal conductivity λ dry 0.05 W/(m∙k)
    Dry density Approx. 152 kg/m³

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors
    • Compensation of thermal bridging effects in ceiling and wall connection areas
    • Optical correction of butt joints

    Properties

    • Environmentally friendly and mould-inhibiting
    • Protects health and the environment, awarded the German Blue Angel
    • Water vapour permeable
    • Capillary-active
    • Easy to apply
    • Preparation
      • Substrate requirements

        The substrate must be clean and capable of bearing a load.

        The substrate must be level.

      • Preparations

        Level off and even out highly uneven substrates – use SP Level to close up joints and even out surfaces.

    • Application
      • Application temperature: min. 5 °C max. 30 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C

      • Use the material to level out any unevenness of < 8 mm in the substrate.

        Apply the material vertically to the substrate with a toothed smoothing trowel.

        Press on the board, beginning at the bottom.

        A full-surface bonding is to be achieved.

    • Application instructions
      • Mark the desired dimensions on the board.

        Cut with a cutter knife or keyhole saw.

        Rework the cut edges with a rasp or file if necessary.

        Place the boards, starting at the bottom.

        Avoid cross joints.

        Make sure that the board surface is aligned correctly (the label "front side" must be visible after application).

        Then, use PP Fill to smooth off and create fine, closed surfaces that are ready for painting.

    • Storage / shelf life
      • Store frost-free
      • Unlimited if stored in frost-free conditions.

    • Usage
      • According to needs

    • General information
      • Typical inherent odour after installation, while the finishing plaster is drying.

        Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • The product must be disposed of in accordance with the official regulations.