SL Fill Q3

Clean, dust-free and capable of supporting a load.

Pre-wet absorbent plaster substrates so that they are slightly damp.

Contact layer

Using a suitable tool, apply the product as a contact layer.

Reinforcing layer

Apply the material with a notched trowel so that a final layer thickness of at least 3 mm is obtained.

Embed the fabric in the centre of the reinforcement layer while it is still wet.

Ensure that fabric sheets overlap by at least 10 cm.

Surface decoration

Apply the material at least 2 mm onto the sufficiently set reinforcement layer.

Smooth the surface using a suitable tool.

Finish the surface once set.

Work wet-on-wet and try not to create streaks.

Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

Depending on the ambient conditions, in heated rooms or draughty areas, use a film or similar apparatus to prevent the material from setting too quickly.

Hairline/shrinkage cracks are safe and are not cause for complaint as they do not impair the properties of the mortar.

Mixing tool, trowel, smoothing trowel, sponge float, plasterer's float

Clean tools with water while the material is still fresh.

If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

Approx. 1.3 kg/m²/mm layer thickness

At least 5 mm as reinforcing and thin-coat plaster

The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

Do not work on substrates where moisture is penetrating from the rear.

The colour that is obtained after drying and hardening depends on the ambient conditions and the processing method. For instance, a freshly smoothed surface will be lighter than one that is smoothed later or roughened. Different grain sizes of the same product may lead to slight differences in colour. Substrates soaked from the back may cause discolouration.

Do not use on gypsum-based substrates.

The mixing water must be of drinking water quality.

Low chromate content in accordance with Directive 2003/53/EC.

Always set up a trial area/trial areas first.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.