Betofix KHB EM

Clean, dust-free and capable of supporting a load.

Reinforcement:
Degree of purity SA 2 ½ if applying corrosion protection, otherwise SA 2

Corrosion protection

Apply two layers of slurry with a thickness of min. 1 mm each, making sure the entire surface is covered.

Waiting time between layers: approx. 30 minutes.

Bonding layer

Using a suitable tool, apply the product as a contact layer.

Carry out subsequent work wet-on-wet within the processing time.

Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

Mixing tool, wide brush, broom, rubber scraper

Clean tools with water while the material is still fresh.

Dry, in unopened containers, 6 months.

Approx. 1.5 kg/m² per coat

The mixing water must be of drinking water quality.

The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.