Article No. 577740
PCC I (RC) concrete replacement mortar for static repair of concrete structures
Product specifications
On delivery
7 days: 8 N/mm²
28 days: 9 N/mm²
90 days: 14 N/mm²
7 days: 48 N/mm²
28 days: 55 N/mm²
90 days: 63 N/mm²
28 days: -0.48 mm/m
90 days: -0.65 mm/m
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Concrete replacement for structurally relevant repairs
- Concrete replacement according to
- DIN EN 1504-3
- Rili-SIB DAfStb 2001
- ZTV-ING - Repair and anode embedding mortar for cathodic corrosion protection
Properties
- High mechanical resistance
- High resistance to water penetration
- Very low shrinkage
- Can be applied by machine
- Freeze/thaw-resistant
-
Preparation
-
Substrate requirements
Concrete surface:
Stable, clean, dust-free
Observe the applicable technical regulations for the following parameters:
- Adhesive pull strength of the substrate
- Minimum roughness/roughness depthPre-wet the substrate so that it is slightly moist.
-
Preparations
Reinforcement:
Degree of purity SA 2 ½ if applying corrosion protection, otherwise SA 2
-
-
Application
-
Working time
(+20 °C): Approx. 60 minutesLayer thickness
Single layer 25 - 100 mm
A bonding layer is required when applying manually.
Apply wet-on-wet.
Subsequent processing
Protect fresh mortar surfaces from wind, direct sunlight, rain and/or frost for at least 3 days so that they do not dry too quickly.
Machine working
Please contact Remmers Technical Service (phone +49 5432 83900) before applying with machine processing.
-
-
Application instructions
-
Protect pretreated reinforcement against corrosion with a double application of Betofix KHB EM.
Use screed rails to ensure that the product is poured to the correct height.
-
-
Working tools / cleaning
-
Mixer, trowel, aluminium rule, finishing trowel, power trowel
-
Clean tools with water while the material is still fresh.
-
-
Storage / shelf life
-
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
-
-
Usage
-
Approx. 2.0 kg/m²/mm coating thickness, or 2.0 kg/dm³
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-
