Article No. 180101
Flame-resistant, light-fast, two-component colour varnish with excellent hiding power
Downloads & documents
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Wood and wood-based materials
- High-quality furniture
- Kitchen and bathroom furniture
- Interior finishing of ships
- Shop fitting and trade fair stands
- Ideal on surfaces that have been pre-treated with Remmers PUR fillers
- As a glass varnish (in conjunction with PUR GLA-820)
- As a metal coating (in conjunction with UMA-824)
- Very good hiding power
- Excellent flow properties
- Can also be used on vertical surfaces
- Excellent resistance to chemicals
- Resistant to hot water and steam
- Fire resistant
- Pleasant feel
- Free of aromatic compounds
The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.
Wood moisture content: 8-12%
Wash off greasy or resin-rich woods/substrates with WV-891 or V-890.
Sand wood using P 100 - 180 grit.
Sand panels using P 180 - 320 grit.
Sand filler using P 240 - 320 grit.
Flow cup gun: nozzle size: 1.8 - 2.0 mm; atomiser air pressure: 2 - 3 bar.
Airless spraying: nozzle size: 0.23 - 0.28 mm, material pressure: 80 - 120 bar.
Airmix spraying: nozzle size: 0.23 - 0.28 mm, material pressure: 80 - 100 bar, atomiser air pressure: 1.2 - 2 bar.
Carry out intermediate sanding (P 240 - 320) immediately before further coats.
Seal opened containers well and use contents as soon as possible.
Check colour, adhesion and compatibility with the substrate by setting up a trial area.
To ensure optimum resistance to metal rings and to improve the resistance to chemicals, we recommend coating with a suitable, light-fast clear varnish.
Dust-dry: after approx. 40 minutes Can be overcoated: after approx. 2 hours Can be stacked: after drying overnight
Practice values at +20 °C and 65% relative humidity.
Low temperatures, poor ventilation and high humidity delay drying.
Ready to use, if necessary dilute with V-890, V-897 or V-893.
Working tools / cleaning
Airless/airmix spraying equipment, flow cup gun
Clean tools using WV-891 Brush Wash or V-890 Thinner.
Ensure that any residue from cleaning is disposed of correctly.
Storage / shelf life
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
100 - 120 ml/m² per coat
Please refer to the relevant test reports/certificates and the Technical Data Sheet for information on certified products and configurations.
To preserve the quality of the surface, we recommend regular cleaning and care using a lint-free cotton cloth. Please use solvent-free and silicone-free cleaning agents.
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
Safety / regulations
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.