Article No. 507101
High-quality, premium sealing tape based on nitrile rubber and coated with non-woven fabric
Downloads & documents
After exposure to liquid chemicals
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Interior and exterior use
- Waterproofing in the transition to water impermeable concrete constructions (PG-ÜBB testing principles)
- Plinth waterproofing
- Waterproofing in a bond
- Connection and integration of flexible, mineral waterproofing slurries with non-mineral building materials and connection areas such as plastic, metal and wood
- Highly flexible
- High expansion capability and elastic recovery
- Special non-woven fabric coating
Clean, dust-free and capable of supporting a load.
Remove projecting seams and mortar remains.
Remove gravel packets and fill cavities.
Clean non-mineral substrates until they are free from residues and degrease; roughen if necessary.
Create a scratch coat of waterproofing material on mineral and roughened substrates.
Refer to the current Technical Data Sheet for detailed information on the single products.
Apply waterproofing material as contact layer, work in Water Stop over the entire surface.
In corner areas, Interior Corner VF and Exterior Corner VF are placed so that they overlap the water stop.
In areas where pipes pass through walls, Wall Gasket VF or a shaped piece made of Water Stop VF 500 can be used.
Depending on the waterproofing product used, the 2nd and 3rd layer of waterproofing is applied over the entire surface.
The permissible application temperatures depend on the product properties of the waterproofing products used.
Apply the waterproofing material crosswise in relation to the tape. The tape must not be damaged.
Working tools / cleaning
For cutting: scissors or knife For waterproofing: roller, wide brush or filling knife
Clean tools with water while the material is still fresh.
Storage / shelf life
Virtually unlimited when stored dry at room temperature and protected from direct sunlight.
According to needs
The current technical regulations must be observed.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Always set up a trial area/trial areas first.
The product must be disposed of in accordance with the official regulations.