• FL fix

    Article No. 281725

    FL fix

    Flexible tile cement

    Colour: FL fix | 2817
    Size / Quantity

    Product specifications

    On delivery

    Foot traffic/ready for use After approx. 12 hours
    Cement bed thickness Up to a maximum of 10 mm
    Open time Approx. 30 minutes (depending on the temperature)
    Bulk density Approx. 1.3 kg/dm³
    Water requirement Approx. 6.5 l / 25 kg

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on floors/walls indoors and outdoors
    • Laying ceramic wall and floor coverings
    • For interior and exterior use
    • Dry, wet and underwater environments
    • Waterproofing in a bond


    • High adhesive pull strength (C 2)
    • Flexible (S 1)
    • High slip resistance (T) and bond strength
    • Extended open time (E)
    • Very low emissions (GEV-EMICODE EC 1Plus)
    • Preparation
      • Substrate requirements

        Clean, dust-free and capable of supporting a load.

      • Preparations

        Remove projecting seams and mortar remains.

        Level the substrate.

        Pretreat highly absorbent substrates with Primer Hydro F.

    • Application
      • Application temperature: min. 5 °C max. 30 °C
      • Mortar cover / Filling knife / Trowel application
      • To increase the adhesive pull strength, apply a scratch coat (contact layer) first.

        Apply the product directly using a suitable toothed trowel.

        Lay the surface covering on the wet mortar bed, pushing down gently.

        Remove wet mortar residue from the top of the surface covering promptly.

        Remove excess mortar from the joint network.


    • Application instructions
      • Do not use on areas directly exposed to sunlight or on heated surfaces.

        Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

        * Natural fillers lead to slight deviations in the amount of water required. The optimum water quantity depends on the building site conditions and the layer thickness.

    • Working tools / cleaning
      • Mortar cover / Filling knife / Trowel application
      • Mixing tool, smoothing trowel, trowel, notched trowel

        Clean tools with water while the material is still fresh.

    • Storage / shelf life
      • Protect form moisture
      • Shelf-life 12 months
      • If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

    • Usage
      • 1.1 kg / mm thick layer / m²
      • Approx. 1.1 kg/m²/mm layer thickness
        4 mm serration: approx. 1.5 kg/m²
        6 mm serration: approx. 2.3 kg/m²
        8 mm serration: approx. 3.0 kg/m²

    • General information
      • Low chromate content in accordance with Directive 2003/53/EC.

        Product characteristics were determined under laboratory conditions at 23° C and 50% humidity.

        The mixing water must be of drinking water quality.

        Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.