Betofix OS 5b+

The substrate must be dry, level, stable and clean. It must also be free of dust, oil, grease and release agents.

Remove projecting seams and mortar remains.

Break off or chamfer corners and edges.

Use a suitable mortar to create a sealing cove.

Seal off indentations > 5 mm using a suitable filling knife.

Roughen the surface of plastic pipes with sandpaper; clean and, if necessary, sand metal pipes.

Apply a scratch coat of the product to act as a contact layer and reduce blistering.

Mixing ratio liquid : powder = 1 : 1.87

Stir the liquid component with a suitable mixing tool.

Loosen the powder component and add it in full to the liquid component.

Mix for approx. 1 minute before suspending the mixing process to allow the air that has been stirred in to escape.

Remove the powder adhering to the side.

Mix again for approx. 2 minutes.

Keep the mixing tool near the bottom of the bucket while mixing.

Apply a scratch coat to the sanded substrate. Use a slurry brush, smoothing trowel or spraying equipment to apply in two layers.

Apply the product in two layers on the previously prepared substrate.

Apply second layer once sufficiently dry.

Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

When using liquid waterproofing materials, exposure to direct sunlight and/or wind can accelerate skin formation and cause blistering.

The maximum total wet coat thickness must not exceed 5 mm.

Moving the material (e.g. by stirring) in the mixing bucket can prevent premature skin formation.

Do not use in direct sunlight.

Protect fresh waterproofing from rain, frost and condensation.

Once dry, protect from mechanical damage.

Please contact Remmers Technical Service (phone +49 5432 83900) before applying with machine processing.

Mixing tool, trowel, wide brush

Clean tools with water while the material is still fresh.

Remove hardened material by tapping or scraping.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 9 months.

Approx. 1.7 kg/m²/mm dry layer thickness
Approx. 3.4 kg/m² at 2 mm dry layer thickness

Low chromate content in accordance with Directive 2003/53/EC.

The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.