Article No. 281725
Flexible tile cement
Product specifications
On delivery
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Laying ceramic wall and floor coverings
- For interior and exterior use
- Dry, wet and underwater environments
- Waterproofing in a bond
Properties
- High adhesive pull strength (C 2)
- Flexible (S 1)
- High slip resistance (T) and bond strength
- Extended open time (E)
- Very low emissions (GEV-EMICODE EC 1Plus)
-
Preparation
-
Substrate requirements
Clean, dust-free and capable of supporting a load.
-
Preparations
Remove projecting seams and mortar remains.
Level the substrate.
Pretreat highly absorbent substrates with Primer Hydro F.
-
-
Application
-
To increase the adhesive pull strength, apply a scratch coat (contact layer) first.
Apply the product directly using a suitable toothed trowel.
Lay the surface covering on the wet mortar bed, pushing down gently.
Remove wet mortar residue from the top of the surface covering promptly.
Remove excess mortar from the joint network.
-
-
Application instructions
-
Do not use on areas directly exposed to sunlight or on heated surfaces.
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
* Natural fillers lead to slight deviations in the amount of water required. The optimum water quantity depends on the building site conditions and the layer thickness.
-
-
Working tools / cleaning
-
Mixing tool, smoothing trowel, trowel, notched trowel
Clean tools with water while the material is still fresh.
-
-
Storage / shelf life
-
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
-
-
Usage
-
Approx. 1.1 kg/m²/mm layer thickness
4 mm serration: approx. 1.5 kg/m²
6 mm serration: approx. 2.3 kg/m²
8 mm serration: approx. 3.0 kg/m²
-
-
General information
-
Low chromate content in accordance with Directive 2003/53/EC.
Product characteristics were determined under laboratory conditions at 23° C and 50% humidity.
The mixing water must be of drinking water quality.
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-
