Article No. 016001
Mineral nonwoven laminated strips made of rigid polyurethane foam for creating capillary-active interior insulation
Product specifications
On delivery
80 mm ≤ d < 120 mm: 0.026 W/(mK)
d ≥ 120 mm: 0.025 W/(mK)
80 mm ≤ d < 120 mm: 0.027 W/(mK)
d ≤120 mm: 0.026 W/(mK)
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Energy efficiency upgrades
- Mould control and prevention in existing buildings
- Implementation of the hygienic minimum heat insulation level in existing buildings
- Improving the room climate by increasing the wall surface temperature
Properties
- Strip-shaped
- Excellent thermal insulation
- Water vapour permeable
- Capillary active when used in a system
- Lambda rating value in the installed state approx. 0.003 W/(mK) higher in each case
- Fire behaviour class B-s1, d0 (DIN EN 13501-1)
- Building material class B1 flame retardant according to DIN 4102-1
- Low construction height, choice of 30, 50, 80 & 120 mm
- Easy to apply
- Thermal insulation material according to DIN 4108-10
-
Preparation
-
Substrate requirements
The substrate must be load-bearing, even, clean, dry and free from adhesion-reducing substances.
Remove wallpaper and dispersion coatings.
-
Preparations
Level off and even out highly uneven substrates – use SP Level to close up joints and even out surfaces.
-
-
Application
-
Pre-wet absorbent substrates.
Apply iQ M universal to the substrate as a scratch coat.
Apply iQ M universal wet-on-wet with a notched trowel as the first mortar layer on the edge insulation strip and wall.
Position and press the iQ-Therm 2.0 strips into the adhesive bed. Finish the interior insulation strip by strip. To do this, prepare the bed joints with iQ M universal. Leave joints between the strips free. Avoid cross-joints!
Align using a floating rule.
-
-
Application instructions
-
Mark the desired lengths on the iQ-Therm 2.0 strips. Cut to size with a cutter knife.
Prepare bed joints with iQ M universal. Do not glue butt joints!
Avoid creating cross joints.
Make sure that full-surface bonding is achieved.
Cut with a cutter knife, insulation knife or plunge saw.
-
-
Working tools / cleaning
-
Cutter knife
-
-
Storage / shelf life
-
Dry and frost-free.
-
-
Usage
-
Approx. 0.85 strips/running m
Approx. 6.8 strips/m²
-
-
General information
-
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
-
-
Disposal instructions
-
The product must be disposed of in accordance with the official regulations.
-
