• Verdickungsadditiv AFM

    Article No. 073881

    Thickening Additive AFM

    Additive for modifying the flowability of Silicone AFM

    Variant
    0738 | Thickening Additive AFM
    Size / Quantity

    Product specifications

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • Reduction in flowability or increase in stability of Silicone AFM
    • Production of skin moulds by brushing on uneven or perpendicular mould surfaces without run-off or sinking

    Properties

    • Cross-linking and viscosity increasing
    • Neutral colour
    • Application
      • Shake before use
      • Shake the container or stir its contents vigorously before use.

        Mix the thickening additive AFM with the ready-mixed silicone AFM in the selected ratio using a spatula or stirrer until homogeneous.

    • Application instructions
      • Single-use pipettes (20 drops = 1 g) or disposable syringes can be used to measure out small quantities of additive.

        At low temperatures, the thickening additive AFM is viscous to solid and can be brought into a readily workable, liquid form by heating.

        The product reacts with moisture in the air.

        Re-seal containers immediately after use.

    • Working tools / cleaning
      • Clean tools immediately after use with thinner and brush cleaner.

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers
      • Shelf-life 12 months
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

        Store in well-sealed, original containers, out of the reach of children and in a dry, cool, well-ventilated room which is protected from direct sunlight and frost. No smoking is permitted in storage areas.

    • General information
      • Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.