• ICS 2K
  • ICS 2K
  • ICS 2K
    • ICS 2K
    • ICS 2K
    • ICS 2K

    Article No. 047611

    ICS 2K

    Ultra-fine, two-component injection paste

    Colour: grey | 0476
    Packaging unit

    Product specifications

    On delivery

    Flexural tensile strength (28 days) Approx. 2.0 N/mm²
    Compressive strength After 7 days: > 5.0 N/mm²
    After 28 days: > 20 N/mm² (M20)
    Initial setting (20 °C) > 8 hours
    Final set (20 °C) > 10 hours
    Bulk density of fresh mortar Approx. 1.7 kg/l
    Maximum grain size < 0.02 mm
    Air void content Approx. 1 vol.-%
    Composition Art. 0475: injection fluid
    Art. 0476: ultra-fine, factory-mixed, hydraulically hardening binder (powder) with high sulphate resistance

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors and outdoors
    • Dry, damp, wet, underwater and underground areas
    • Injection into cracks in concrete
    • Filling cracks and cavities
    • Strengthening in the subsoil

    Properties

    • Low viscosity (very good flow properties)
    • Low shrinkage
    • High sulphate resistance and low active alkali content (SR/NA)
    • High early strength
    • Water impermeable
    • Freeze/thaw-resistant
    • Preparation
      • Substrate requirements

        Drilling channel must be free of drill dust.

      • Preparations

        Strengthening hollow masonry

        Creation of drill holes: diameter 18 - 30 mm, angle of inclination approx. 45°, hole depth up to max. 5 cm from end of wall.

    • Application
      • Bore hole saturation
      • Application temperature: min. 5 °C max. 30 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C

      • Pressureless, via funnel.

        Inject using suitable injection equipment and injection packers.

    • Application instructions
      • Do not mix with other products.

    • Working tools / cleaning
      • Bore hole saturation
      • Mixer, injection device, packers (e.g. Desoi packers and equipment or Polyplan packers and pumps)

      • Clean tools with water while the material is still fresh.

    • Storage / shelf life
      • Shelf-life 12 months
      • Store frost-free and cool / protect for moisture / close containers
      • If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

    • Usage
      • Approx. 1.7 kg / l void
      • Approx. 1.7 kg/l cavity

    • General information
      • Do not use on gypsum-based substrates.

        The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

        Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.