Induline IW-130

The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.

Dimensionally stable wood building elements: wood moisture content 11-15%

Before applying the material, all trimming work such as milling, sawing and drilling must be complete.

Stir well, including during application or after a break in work.

Brush application, dipping and flow coating.

Once dry, apply further coatings.

Seal opened containers well and use contents as soon as possible.

Check colour, adhesion and compatibility with the substrate by setting up a trial area.

Before coating technically modified woods and wood-based materials, apply the product to a trial surface and conduct a suitability test on the desired area of use.

Overcoating: after approx. 4 hours

Practice values at +20 °C and 65% relative humidity.

Low temperatures, poor ventilation and high humidity delay drying.

Ready to use

Paintbrush, dipping tank, flow coating facility

Clean tools with water or Aqua RK-898 Cleaning Concentrate immediately after use.

Ensure that any residue from cleaning is disposed of correctly.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

80 - 120 ml/m² per coat

The application rate is dependent on the type of wood and the absorbency of the substrate.

Opaque coating system for dimensionally stable wood building elements
Wood types: spruce, pine, larch, meranti and oak
Impregnation: Induline IW-130
Primer: Induline GW-209
Intermediate coat: Induline ZW-400 / Induline ZW-425
Finishing coat: Induline DW-6XX

Translucent coating systems for dimensionally stable wood building elements
Softwood
Wood types: spruce, pine and larch
Impregnation: Induline IW-130
Primer: Induline GW-360
Intermediate and finishing coat: Induline LW-7XX

Hardwood
Wood types: meranti and oak
Impregnation: Induline IW-130
Primer: Induline GW-360
Intermediate coat: Induline ZW-502i
Finishing coat: 2x Induline LW-7XX

According to the current state of technology (including DIN 68800-1 in Germany), wood preservation measures must also be planned for non-load-bearing wood building elements promptly and carefully, in coordination with all parties involved in the construction (architect, developer, workers), taking into consideration the legal requirements and local conditions. The use of Induline IW-130 should therefore always be indicated in a suitable way prior to purchase, or agreed in writing with the client beforehand. Failure to comply with this requirement could result in country-specific and project-specific conflicts with legal requirements, standards or certification systems. Upon request, Remmers Technical Service would be happy to provide a suitable draft template for the agreement on the use of Induline IW-130 as a wood preservative on the wooden building elements.

Observe the information sheets “Upkeep and Maintenance of Dipping Tanks and Flow Coating Facilities” and “Information on Workplace Hygiene”.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.