Article No. 237405
Clear, single-component sealing varnish for application by roller
Product specifications
On delivery
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Interior wood
- For wooden surfaces in living areas that are subjected to heavy use
- For use in residential and other buildings (e.g. parquet, steps, floorboards)
- OSB panels and cork flooring
Properties
- Resistant to abrasion and scratches
- Excellent emphasis of the grain
- Excellent water resistance
- Good flow properties on horizontal surfaces
- 2K-ready: increased resistance to chemicals, hand creams, scratches and abrasions by adding 2% Aqua VGA-485
-
Preparation
-
Substrate requirements
The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.
Wood moisture content: 8-12%
-
Preparations
Sand wood using P 100 - 180 grit.
Wash off greasy or resin-rich woods/substrates with WV-891 or V-890. Use UN-894 indoors on the construction site. Ensure good ventilation for solvents.
Remove resin galls.
-
-
Application
-
Shake well before use.
Apply using a brush or roller.
Once dry, apply the next coat on the same day.
After drying and intermediate sanding (P 180 - 320), apply a finishing coat.
Seal opened containers well and use contents as soon as possible.
-
Application instructions
-
Check colour, adhesion and compatibility with the substrate by setting up a trial area.
Before coating technically modified woods and wood-based materials, apply the product to a trial surface and conduct a suitability test on the desired area of use.
-
Drying
Dust-dry: after approx. 1 hour
Ready for next coat: after approx. 4 hours
Full loading capacity: after approx. 7 daysPractice values at +20 °C and 65% relative humidity.
Low temperatures, poor ventilation and high humidity delay drying.
-
Thinning
Ready to use. If necessary, dilute with max. 5% water.
-
Working tools / cleaning
-
Sealant roller with microfibre cover, pile height approx. 8-12 mm, acrylic brush
Clean tools immediately after use with water and detergent.
Ensure that any residue from cleaning is disposed of correctly.
-
Storage / shelf life
-
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
-
Usage
-
100 - 120 ml/m² per coat
-
General information
-
DIN EN 71-3 "Migration of certain elements":
This product complies with the limits for the migration of heavy metals to children's toys according to DIN EN 71-3 and thus fulfils one of several further requirements for the safety of children's toys according to the EU "Toy Directive" (2009/48/EC).On swaying wooden flooring or wooden flooring that is not resistant against shear forces, as well as on heated flooring, there is a risk of torn joints due to the tendency of aqueous sealants to bond at the sides. In such cases, we recommend priming with Aqua MSV-403 Parquet Primer.
Use breathable materials to cover the wood components once varnished.
Clean once a week as required by mopping with a standard commercially available care product for varnished floors.
Please refer to the relevant test reports/certificates and the Technical Data Sheet for information on certified products and configurations.
Observe the "Care instructions for sealed flooring and stairs".
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-