Article No. 780112
Plastoelastic sealing and adhesive compound
Downloads & documents
Product specifications
On delivery
(DIN EN ISO 1183-1A) 1.07 g/cm³
Once fully cured
Once fully cured
100% (DIN EN ISO 8339) 0.02 N/mm²
(DIN EN ISO 8339) > 200%
(DIN EN ISO 10563) Approx. < 30%
(DIN EN 15651-1) ± 7.5%
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Roofing trade
- Tinsmiths and installers
- General bonding work in construction and woodworking
Properties
- High adhesive power even on damp substrates
- Compatible with bitumen
- Universal adhesion
- Can be overcoated
- Contains solvents
-
Preparation
-
Preparations
The substrate must be clean, free of grease and capable of supporting a load. Metal must be bare.
-
-
Application
-
Application requirements
Temperature of the material, air and substrate: from min. -5 °C to max. +35 °C
-
Apply the material on one side, spread evenly and press the parts together.
Use a moistened spatula to remove excess material.
-
-
Application instructions
-
When used on coatings, the material may cause (temporary) initial dissolving; set up a trial area.
Do not allow the product to come into contact with polystyrene.
Not for permanent water loads.
Do not heat the reacted material to above +60 °C.
Bubbles may form in the material when applied at high temperatures and in large gaps.
-
-
Working tools / cleaning
-
Manual gun, sealant gun, spatula, joint smoothing trowel
-
Clean with V 101 in the fresh and reacted state.
-
-
Storage / shelf life
-
At least 36 months in unopened, original containers stored cool, dry and protected from frost.
-
-
Usage
-
Approx. 100 ml/m for a 1 cm² joint cross-section
-
-
General information
-
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-
