FL grout white

Joint areas must be dry.

Protect ungrouted exterior surfaces from rain.

Clean excess adhesive from joints.

Use a foam rubber scraper/grouting scraper to apply the grout over the entire surface and press into the joints.

Level off sharply and remove excess material.

Use a slightly damp sponge to remove grout residue after it has set.

Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

Do not use on areas directly exposed to sunlight or on heated surfaces.

Touch the material to determine whether it has hardened sufficiently and is ready for washing.

Keep the amount of water used for cleaning to a minimum.

Always use clean water for the final cleaning process.

Clean with a damp sponge, not a dry cloth. There is a risk of discolouration due to rubbing the dried grout into the joints while they are still wet.

Protect the material from drying too quickly.

Minor colour variations are possible. Where possible, only use grout with the same batch number for the same project.

On polished fine stoneware, colour pigments can settle into any micropores present in the surface of the tiles. A strong colour contrast between the tiles and joints is therefore not advised. Set up a trial area if necessary.

Mixing tool, rustproof trowel, grouting board, sponge float, sponge

Clean tools with water while the material is still fresh.

If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

Approx. 1.8 kg/m²/mm layer thickness

The precise application rate depends on the joint width and depth, and on the tile format

Low chromate content in accordance with Directive 2003/53/EC.

The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

The mixing water must be of drinking water quality.

May contain traces of pyrite (iron sulphide).

The level of moisture in the substructure and the ambient conditions affect the hardening process and the colour brilliance.

Light colours that are easily affected by dirt should not be used on floors.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.