Article No. 455102
Self-adhesive copper tape
Downloads & documents
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- System component in electrically conductive systems
- Copper band in the system SL Floor WHG AS (AbZ Z-59.12-303)
Properties
- Self-adhesive
-
Preparation
-
Substrate requirements
The substrate must be load-bearing, dimensionally stable, solid, free of loose parts, dust, oils, grease, rubber marks and any other substances that could interfere with adhesion. It must be primed so as to remove all surface pores.
Before the application of the product a smooth surface must be produced, e.g. with a scratch coat.
Suitable Remmers epoxy primers, epoxy scratch coats or epoxy mortars must always be used.
See the current Technical Data Sheet of the product in question and the system recommendations for more detailed information.
-
Preparations
Install earthing elements and copper strands prior to application, based on the size and shape of the surface. Make sure that no point on the surface is more than 10 m from an earthing point or a connected copper strand.
The connection to the equipotential bonding must be established by an authorised specialist firm.
-
-
Storage / shelf life
-
Unlimited if stored dry.
-
-
Safety / regulations
-
Further information concerning safety during transport, storage and handling as well as on disposal and ecology can be found in the latest Safety Data Sheet.
-
