SL Fill Q4

Clean, dust-free and capable of supporting a load.

Pre-wet the substrate so that it is slightly moist.

Apply product in the desired coating thickness.

Smooth the surface using a suitable tool.

Can be sanded once set.

Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

Protect the material from drying too quickly.

Hairline/shrinkage cracks are safe and are not cause for complaint as they do not impair the properties of the mortar.

Mixing tool, trowel, smoothing trowel, sponge float, plasterer's float

Clean tools with water while the material is still fresh.

If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

Approx. 2.2 kg/m² for a 2 mm layer thickness

Do not work on substrates where moisture is penetrating from the rear.

The colour that is obtained after drying and hardening depends on the ambient conditions and the processing method. For instance, a freshly smoothed surface will be lighter than one that is smoothed later or roughened. Different grain sizes of the same product may lead to slight differences in colour. Substrates soaked from the back may cause discolouration.

May contain traces of pyrite (iron sulphide).

Do not use on gypsum-based substrates.

The mixing water must be of drinking water quality.

Low chromate content in accordance with Directive 2003/53/EC.

Always set up a trial area/trial areas first.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.