Induline ZW-405

The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.

Dimensionally stable wood building elements: wood moisture content 11-15%

If necessary, impregnate non-resistant woods with a wood preservative* (*Use biocides safely. Always read the label and product information before use).

If necessary, protect parapet joints with Induline V-Joint Protection or Induline AF-920.

Ensure good ventilation.

If necessary, check compatibility with the substrate and sealing effect by applying a trial coat.

With water based coating systems, there is always a residual risk that substances contained in the wood will cause discolouration.

Bleeding resin is a natural phenomenon and cannot be prevented by coating measures, see BFS Code of Practice No. 18.

The product's sealing effect may be impaired if it is diluted too thinly, if the wood is too wet or if the recommended coating sequence, application volumes and drying times are not observed.

Do not use in direct sunlight, or below 15°C or above 30°C.

Relative humidity must not exceed 85%.

Caution: surfaces coated with this product may cling together. Avoid direct contact between coated surfaces.

Dust dry: after approx. 30 minutes
Touch dry: after approx. 1 hour
Ready for overcoating: after approx. 4 hours
Leaving to dry overnight significantly improves sandability.

Practice values at +20 °C and 65% relative humidity.

Low temperatures, poor ventilation and high humidity delay drying.

Dilute with water if necessary (max. 5%).

Manual spray guns, automatic spraying equipment

Clean tools with water or Aqua RK-898 Cleaning Concentrate immediately after use.

Ensure that any residue from cleaning is disposed of correctly.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

150 - 200 ml/m² per coat
(corresponds to a wet film thickness of approx. 150 - 200 μm and a dry film thickness of approx. 75 - 100 μm)

Sealing compounds must be compatible with the coating and may only be applied once the coating has dried thoroughly.

Only use sealing profiles that are free of plasticisers.

Wood building elements which have been treated with an intermediate coating should not be exposed to weathering until a finishing coat has been applied.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.