• Verdickungsadditiv AFM

    Article No. 073881

    Thickening Additive AFM

    Additive for modifying the flowability of Silicone AFM

    Variant
    0738 | Thickening Additive AFM
    Size / Quantity

    Product specifications

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • Reduction in flowability or increase in stability of Silicone AFM
    • Production of skin moulds by brushing on uneven or perpendicular mould surfaces without run-off or sinking

    Properties

    • Cross-linking and viscosity increasing
    • Neutral colour
    • Application
      • Shake before use
      • Shake the container or stir its contents vigorously before use.

        Mix the thickening additive AFM with the ready-mixed silicone AFM in the selected ratio using a spatula or stirrer until homogeneous.

    • Application instructions
      • Single-use pipettes (20 drops = 1 g) or disposable syringes can be used to measure out small quantities of additive.

        At low temperatures, the thickening additive AFM is viscous to solid and can be brought into a readily workable, liquid form by heating.

        The product reacts with moisture in the air.

        Re-seal containers immediately after use.

    • Working tools / cleaning
      • Clean tools immediately after use with thinner and brush cleaner.

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers
      • Shelf-life 12 months
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

        Store in well-sealed, original containers, out of the reach of children and in a dry, cool, well-ventilated room which is protected from direct sunlight and frost. No smoking is permitted in storage areas.

    • General information
      • Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.