PU Garage Coating

The 2K epoxy primer belonging to the system must be completely dry and must adhere sufficiently to the substrate. In case of doubt, check the adhesion by means of a grid scratch test. The waiting time between priming and the PU garage coating is at least 16 and max. 48 hours. If these interval times are exceeded, the primer must be prepared again by sanding with a disc sanding machine fitted with a 120 grit sanding grid, for example.

Stir well before using.

Evenly apply the ready-to-use mixture, e.g. using a Remmers epoxy roller (25 cm) and roll it on crosswise. Puddle formation must be avoided. Apply the material with a suitable flat brush and 10 cm epoxy roller along rising components, in hard-to-reach areas and corners.

Applying a coating to concrete and cement, interior and exterior (covered outdoor areas):

Prime 1x with 2K Epoxy Primer.

Then apply at least 2 undiluted coats of PU Garage Coating.

Applying a coating on top of old coatings, or touching up a coating:

Check the compatibility of old coatings.

Prepare the substrate, repair any defects.

Then apply at least 2 undiluted coats of PU Garage Coating.

In case of doubt, the adhesion should be checked by means of a grid scratch test.

The usual protective measures must be observed when using low-pollutant paints and varnishes.

When coating continuous surfaces, only use materials with the same batch number as slight differences in colour, gloss and texture may occur.

Low temperatures and high humidity delay drying.

Paintbrush, nylon roller with min. 10 mm pile height

Clean tools, equipment and any splashed material immediately with water while still fresh.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 24 months.

Approx. 160 ml/m² per coat depending on the surface condition.
At least 2 coats are required.

Please secure the container against tipping over and leaking during transport!

Do not allow water to pool.

When properly applied, the PU Garage Coating can be driven on by vehicles with pneumatic tyres and is generally insensitive to discolouration caused by car tyres. However, should discolouration occur due to plasticiser migration as a result of the different manufacturing processes, rubber compositions or high tyre temperatures, this discolouration has no negative impact on the usage properties. In general, plasticiser migration – especially in the case of very soft tyres – cannot be ruled out for any floor covering.

Slipping hazard in wet conditions.

Colour information and colour prints are non-binding. Colour deviations are possible depending on the substrate and printing technique. After drying, the final colour will differ from the fresh colour in the container.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.