Tape VF 120 [eco]

Clean, dust-free and capable of supporting a load.

Remove projecting seams and mortar remains.

Remove gravel packets and fill cavities.

Clean non-mineral substrates until they are free from residues and degrease; roughen if necessary.

Create a scratch coat of waterproofing material on mineral and roughened substrates.

Refer to the current Technical Data Sheet for detailed information on the single products.

Apply waterproofing material as contact layer, work in Water Stop over the entire surface.

In corner areas, Interior Corner VF and Exterior Corner VF are placed so that they overlap the water stop.

In areas where pipes pass through walls, Wall Gasket VF or a shaped piece made of Water Stop VF 500 can be used.

Depending on the waterproofing product used, the 2nd and 3rd layer of waterproofing is applied over the entire surface.

The permissible application temperatures depend on the product properties of the waterproofing products used.

Apply the waterproofing material crosswise in relation to the tape. The tape must not be damaged.

For cutting: scissors or knife
For sealing: roller, wide brush or scraper

Clean tools with water while the material is still fresh.

Virtually unlimited when stored dry at room temperature and protected from direct sunlight.

According to needs

The current technical regulations must be observed.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Always set up a trial area/trial areas first.