Article No. 286625
Flexible, fast-setting tile cement
Product specifications
On delivery
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Laying ceramic wall and floor coverings
- For interior and exterior use
- Dry, wet and underwater environments
- Levelling of substrates with unevenness up to 5 mm
- Substrates with increased deformation behaviour
Properties
- High adhesive pull strength (C 2)
- Flexible (S 1)
- Fast setting (F)
- Ready for foot traffic and grouting after approx. 3 hours
- High slip resistance (T) and bond strength
- Extended open time (E)
-
Preparation
-
Substrate requirements
Clean, dust-free and capable of supporting a load.
-
Preparations
Remove projecting seams and mortar remains.
Level the substrate.
Pretreat highly absorbent substrates with Primer Hydro F.
-
-
Application
-
To increase the adhesive pull strength, apply a scratch coat (contact layer) first.
Apply the product directly using a suitable toothed trowel.
Lay the surface covering on the wet mortar bed, pushing down gently.
Remove wet mortar residue from the top of the surface covering promptly.
Remove excess mortar from the joint network.
-
-
Application instructions
-
Do not use on areas directly exposed to sunlight or on heated surfaces.
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
When using with heated flooring, a closed layer of mortar 2 mm thick must be created beneath the floor covering in order to ensure correct functioning.
When laying on existing, tightly adhering old surface coverings, apply a scratch coat before laying the new covering.
-
-
Working tools / cleaning
-
Mixing tool, finishing trowel, toothed scraper, trowel or smoothing trowel
-
Clean tools with water while the material is still fresh.
-
-
Storage / shelf life
-
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
-
-
Usage
-
Approx. 1.1 kg/m²/mm coating thickness
At 4 mm approx. 1.6 kg/m²
At 6 mm approx. 2.3 kg/m²
At 8 mm approx. 2.9 kg/m²
-
-
General information
-
Low chromate content in accordance with Directive 2003/53/EC.
The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.
The mixing water must be of drinking water quality.
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-
