Article No. 750112
All-round hybrid sealant
Product specifications
On delivery
Once fully cured
Once fully cured
100% (DIN EN ISO 8339) > 0.4 N/mm²
(DIN EN ISO 7389) > 70%
(DIN EN ISO 10563) < 5%
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Joints subjected to mechanical and chemical stresses
- Waterproofing for interior and exterior construction and expansion joints
- Multi-storey and underground car parks
- Food industry & pharmaceutical companies
- Storage and production areas
Properties
- High adhesion to a wide range of substrates
- Quick, blister-free hardening
- Highly resistant to mechanical and chemical stresses
- Extremely elastic
- Solvent-free
- Can be coated/painted over
- Good resistance to weathering and ageing
- No discolouration on natural stone
- Very low emissions (GEV-EMICODE EC 1Plus)
- Complies with the principles for the health assessment of construction products used indoors (AgBB scheme)
- Safe in contact with food (ISEGA certificate)
-
Preparation
-
Substrate requirements
The bonding surfaces must be stable, dry, clean and free of grease, oil, release agents and other contaminants. Metals must be bare.
MS 360 is capable of adhering directly to mineral substrates such as concrete, screed, synthetic resin screed and PU concrete without the need for a primer. However, for other or highly absorbent substrates, it is recommended to carry out adhesion tests prior to application. The use of a primer, such as Epoxy MT 100 NEW, can significantly improve adhesion.
-
Preparations
When using in construction, comply with the joint dimensions according to DIN 18540.
Avoid three-sided adhesion.
Joints that are too deep should be filled with round cords.
-
-
Application
-
Apply the sealant vertically in grooves with a minimum spacing of 10 cm and a maximum spacing of 20 cm. Do not apply the sealant in dots! The optimum sealant thickness is 2 to 3 mm.
-
-
Application instructions
-
Skin formation and hardening depend on storage and change as the product ages.
Hardening times increase at increasing joint depths.
MS 360 also adheres to damp substrates. However, the adhesion achieved may be lower.
-
-
Working tools / cleaning
-
Manual and compressed air gun, scraper, adhesive tape
The compound can be removed in the fresh state with V 101 Thinner; after it has cross-linked, it can only be removed by mechanical means, after swelling with V 101 if necessary.
-
-
Storage / shelf life
-
If stored in the unopened original container in a cool, dry place protected from frost, the product will keep for at least 12 months.
-
-
Usage
-
Approx. 100 ml/running metre for a 1 cm² joint cross-section
-
-
General information
-
MS 360 does not adhere to PE, PP, PC, PMMA, PTFE, soft plastics, neoprene and bituminous surfaces. After grouting, environmental influences on the colours of MS 360 cannot be ruled out. High resistance to (salt) water, aliphatic solvents, hydrocarbons, ketones, esters, alcohols, diluted acids and alkalis. Poor resistance to aromatic solvents, highly concentrated acids and chlorinated hydrocarbons. MS 360 is not recommended for use as a glass sealant!
-
-
Disposal instructions
-
Larger product residues must be disposed of in the original packaging in accordance with the applicable regulations.
Must not be disposed of with household waste. Avoid product release, e.g. through dust, during use. Completely empty packaging must be recycled.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-