Induline LW-730

The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.

Wood building elements with limited or no dimensional stability: wood moisture content max. 18%

If necessary, impregnate non-resistant woods with a wood preservative* (*Use biocides safely. Always read the label and product information before use).

Temperature of the material, air and substrate: from +5 °C to +25 °C.

Stir well, including during application or after a break in work.

Apply with a brush, roller or by spraying.

Once dry, apply further coatings.

Seal opened containers well and use contents as soon as possible.

If you wish to use this product in a pigmented version (special colour), please consult Remmers Technical Service beforehand.

Before coating technically modified woods and wood-based materials, apply the product to a trial surface and conduct a suitability test on the desired area of use.

Check colour, adhesion and compatibility with the substrate by setting up a trial area.

Substances in oak may bleed, causing dark discolouration, when coated with water dilutable dispersion stains.

If you wish to use this product outside its primary area of application (house and hall construction), please consult Remmers Technical Service beforehand.

Can be overcoated: after approx. 2 hours
(Practice values at 20°C and 65% relative humidity)

Forced drying: after approx. 10 minutes flash-off zone (at approx. 20 °C and 65-70% RH) / 30 minutes drying phase (approx. 45 °C, 1 ms air circulation) / 20 minutes cooling phase

Low temperatures and high humidity delay drying.

Ready to use.
If necessary, dilute with water (max. 5%)

Acrylic brush, flat brush, short-pile roller, airless/airmix spraying equipment, board coating machine, sponge, carpet board, mop

Clean tools with water or Aqua RK-898 Cleaning Concentrate immediately after use.

Ensure that any residue from cleaning is disposed of correctly.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

80-120 ml/m² per coat

On planed larch and softwoods with a high resin content, the coating may have reduced adhesion and resistance to weathering. This is especially the case on horizontal year rings, knots and areas of winter growth that are high in resin. Maintenance and renovation must be carried out more frequently on these surfaces.
The only remedy for this is pre-weathering or very coarse sanding (P80).
If these wood types are rough-sawn, considerably longer maintenance and renovation intervals are to be expected.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.