Betofix KFM

Clean, dust-free and capable of supporting a load.

Pre-wet the substrate so that it is slightly moist.

The pre-wet substrate must still be slightly absorbent.

Use the product to apply a scratch coat.

Dilute the product slightly before applying the product to hard-to-reach places in the form of contact sludge.

Layer thickness, single-layered 5–25 mm

Layer thickness, double-layered < 50 mm, with the second layer applied while the first is still wet

Single layer thickness in broken-out areas < 100 mm

Hairline/shrinkage cracks are safe and are not cause for complaint as they do not impair the properties of the mortar.

Protect wet mortar surfaces against frost, rain and drying out too quickly for at least 4 days.

Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

Please contact Remmers Technical Service (phone +49 5432 83900) before applying with machine processing.

Mixing tool, trowel, smoothing trowel

Clean tools with water while the material is still fresh.

If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

The mixing water must be of drinking water quality.

May contain traces of pyrite (iron sulphide).

Low chromate content in accordance with Directive 2003/53/EC.

The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

Larger product residues must be disposed of in the original packaging in accordance with the applicable regulations.
Must not be disposed of with household waste. Avoid product release, e.g. through dust, during use. Completely empty packaging must be recycled.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.