Article No. 073881
Additive for modifying the flowability of Silicone AFM
Downloads & documents
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Reduction in flowability or increase in stability of Silicone AFM
- Production of skin moulds by brushing on uneven or perpendicular mould surfaces without run-off or sinking
Properties
- Cross-linking and viscosity increasing
- Neutral colour
-
Application
-
Shake the container or stir its contents vigorously before use.
Mix the thickening additive AFM with the ready-mixed silicone AFM in the selected ratio using a spatula or stirrer until homogeneous.
-
Application instructions
-
Single-use pipettes (20 drops = 1 g) or disposable syringes can be used to measure out small quantities of additive.
At low temperatures, the thickening additive AFM is viscous to solid and can be brought into a readily workable, liquid form by heating.
The product reacts with moisture in the air.
Re-seal containers immediately after use.
-
-
Working tools / cleaning
-
Clean tools immediately after use with thinner and brush cleaner.
-
-
Storage / shelf life
-
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
Store in well-sealed, original containers, out of the reach of children and in a dry, cool, well-ventilated room which is protected from direct sunlight and frost. No smoking is permitted in storage areas.
-
General information
-
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-