• BTM Bio Release Concentrate

    Article No. 110830

    BTM Bio Release Concentrate

    Biodegradable release concentrate

    Variant
    1108 | BTM Bio Release Concentrate
    Packaging unit

    Product specifications

    On delivery

    Density (20°C) 0.92 g/cm³
    Colour yellowish brown
    Flash point > 200
    Consistency liquid

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors and outdoors
    • Absorbent and non-absorbent formwork substrates
    • Heated formwork up to +80 °C
    • Release agent for hot bitumen

    Properties

    • Universal use with a wide range of formworks
    • Excellent release action, weather-resistant and non-damaging to the formwork
    • Application by brush or spraying
    • Economical use thanks to application-specific dilution
    • Biodegradable
    • Low odour
    • Preparation
      • Substrate requirements

        Clean any dirt or wax off the formwork.

      • Preparations

        Before using new wooden formwork for the first time, coat with a sufficient quantity of cement paste. Brush off the next day and treat with release agent.

    • Application
      • By brush / By roller/ Low pressure spraying
      • Application temperature: min. 5 °C max. 80 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +80 °C.

      • Apply a thin layer of the material.

        Make sure that no pools form.

    • Working tools / cleaning
      • By brush / By roller/ Low pressure spraying
      • Low-pressure spraying equipment, surface brush, roller, short-hair broom, rubber scraper, cloth

      • Clean tools immediately after use with V 101 Thinner.

    • Storage / shelf life
      • Shelf-life 12 months
      • Store frost-free and cool / protect for moisture / close containers
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

    • Usage
      • Depending on the application / m²
      • Dependent on application and formwork surface: As formwork oil: approx. 1 l concentrate / 200 – 300 m² depending on the absorbency As bitumen release agent: approx. 1 l concentrate / 30 – 50 m²

    • General information
      • When using on fair-faced concrete surfaces according to the DBV (German Institute for Concrete) data sheet, set up a trial area depending on the fair-faced concrete class.

        Remove all material residue from the concrete surface before applying any coatings.

        Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.