Article No. 500301
Highly elastic, self-adhesive butyl rubber waterproofing tape on polypropylene non-woven fabric
Downloads & documents
XA 250 = 250 mm
XA 250 = approx. 0.8 mm
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Interior and exterior use
- Connection and integration of MB 2K, MB TX 2K, Betofix OS 5b+; PMBCs and flexible, mineral waterproofing slurries to non-mineral building materials and connection areas such as plastic, metal and wood.
- High adhesive strength
- Special non-woven fabric coating
Load-bearing, dry, clean and dust-free.
Remove projecting seams and mortar remains.
Remove gravel packets and fill cavities.
Clean non-mineral substrates until they are free from residues and degrease; roughen if necessary.
Create a scratch coat of waterproofing material on mineral and roughened substrates.
Refer to the current Technical Data Sheet for detailed information on the single products.
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
Affix directly to the prepared substrate.
In corner areas, notch the tape and stick it down so that it is overlapping.
Apply the waterproofing material over the entire surface of the tape.
Carefully loosen partial adhesions of the silicone film, then continue to peel off the film.
The permissible application temperatures depend on the product properties of the waterproofing products used.
The joint tape must not be damaged when working over it.
Working tools / cleaning
For cutting: scissors or knife
For waterproofing: roller, wide brush, filler knife
Clean tools with water while the material is still fresh.
Storage / shelf life
Virtually unlimited when stored dry at room temperature and protected from direct sunlight.
Roller must be stored upright to prevent pressure points.
According to needs
The current technical regulations must be observed.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
Always set up a trial area/trial areas first.
The product must be disposed of in accordance with the official regulations.