Article No. 154612
Two-component PU foam for door frame assembly
Product specifications
On delivery
Once fully cured
Once fully cured
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Rapid assembly of building components
- Foaming of door frames, window frames, roller blind housing and masonry
- Closing pipe lead-throughs, service ducts and voids
Properties
- Specially designed for application without guns
- Sets quickly in just a few minutes
- High foam yield
- No post-expansion
- Very high adhesive power
- No inclusion of water or air needed for the reaction
- Excellent isolation, sound and heat insulation
-
Preparation
-
Substrate requirements
The substrate must be free from dirt, dust, loose parts, oil, grease etc. and should be as dry as possible.
Do not pre-wet!
-
Preparations
Turn the plastic wheel on the base of the can to the right a few times.
Hold with the valve facing downwards and shake the can vigorously approx. 20 times.
Position the angled adapter.
-
-
Application
-
Apply with the valve facing downwards.
The foam leaving the can must have a uniform light green colour. Repeat the shaking if necessary.
Once mixed, use the contents of the can within the working time of approx. 5 minutes, otherwise the foam will harden in the can (danger of bursting).
-
-
Application instructions
-
Drying
Adhesion-free: approx. 5 minutes (at +20 °C).
Can be cut: after approx. 13 minutes (at +20 °C)
Can be spread after: approx. 45 minutes (at +20 °C)
Fully loadable after: approx. 4 hours (at +20 °C)
-
-
Working tools / cleaning
-
Hardened foam is insoluble.
Remove impurities immediately with foam cleaner.
-
-
Storage / shelf life
-
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
-
-
Usage
-
One can is sufficient for 2 door frames
Yield: approx. 10 l/can (free-foamed) -
Apply to a large enough trial area to determine the precise amount required.
-
-
General information
-
Always set up a trial area/trial areas first.
Do not heat can to above +50 °C.
The applicable regulations and legal requirements must be observed.
The relevant test certificates must be observed when planning and carrying out work.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-
