Article No. 664311
Pigmented, matt sealant
Product specifications
On delivery
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Matt PU sealant on Remmers EP and PU coatings
Properties
- Matt surface
- Moisture-curing
- Can be subjected to mechanical loads
- Can be subjected to chemical loads
- Coating compatibility test
-
Preparation
-
Substrate requirements
The substrate must be firm, dimensionally stable, capable of bearing loads and free of loose constituents, dust, oil, grease, rubber marks and other substances that could interfere with adhesion.
The substrate must be prepared using suitable Remmers products.
-
-
Preparation
-
Combination container
Add the entire quantity of the hardener (component B) to the base compound (component A).
Mix thoroughly with a slow-speed electric mixer
(approx. 300 - 400 rpm).Pour the mixture into a separate container and mix again thoroughly.
Mix for at least 3 minutes.
Insufficient mixing is indicated by streaks forming.
-
Application
-
Higher temperatures and higher absolute humidity reduce the specified times, while lower temperatures and lower absolute humidity increase them.
-
Working tools / cleaning
-
Epoxy roller, PU roller, mixer
-
More detailed information can be found in the Remmers Tool Programme.
Clean tools, equipment and splashed material immediately while fresh with V 101.
Take suitable protective and waste disposal measures when cleaning.
-
Storage / shelf life
-
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 9 months.
-
Usage
-
approx. 0.13 kg/m²
-
-
Application examples
-
Sealant
Apply the material to the surface and spread it evenly with a suitable 25 cm PU roller in a criss-cross pattern and then apply it with a 50 cm epoxy roller. Replace the rollers with new ones after 30 minutes.
Always work wet-on-wet.
For small areas, work from a paint tray.
approx. 0.13 kg/m²
-
-
General information
-
Unless otherwise specified, all of the values and application rates given above have been determined under laboratory conditions (20 °C) using standard colours. Slight deviations from these values may arise if the product is worked with on site.
Use sufficiently experienced personnel to ensure that surfaces are as even as possible.
If the processing time is exceeded, roller marks or differences in degree of gloss and colour may occur.
When coating continuous surfaces, only use materials with the same batch number as slight differences in colour, gloss and texture may occur.
Shades of colour with low hiding power (e.g. yellow, red or orange) tend to have a translucent effect on the subsequently applied sealant. In such cases, it is necessary to build up a coordinated colour, e.g. with multiple layers of sealant.
In case of repairs on the surface or working up to existing surfaces, there will be a visible transition in appearance and texture.
Uneven application and large temperature differences on the surface may lead to a non-uniform surface appearance due to differences in the degree of gloss.
Excessively thick layers, sweat drops or dripping material will cause the sealant to foam up.
Abrasive mechanical loads leave traces of wear.
Suitable for vehicle traffic with rubber tyres; not suitable for vehicle loads with metal or polyamide tyres nor for dynamic point loads.
Further notes on working, system construction and maintenance of the listed products can be found in the latest Technical Data Sheets and the Remmers system recommendations.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-