Article No. 495401
Downloads & documents
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Non-destructive testing of water absorption/time unit
- Checking the effectiveness of hydrophobising agents
- Can be used to estimate the water absorption coefficient according to DIN EN 772-11
Properties
- Contents:
4 x Funcosil test tubes
1 x Funcosil test plate
1 x digital stopwatch
1 x sprayer (polyethylene)
1 x palette knife (width 30 mm)
1 x butyl rubber (fixing)
-
Preparation
-
Substrate requirements
Clean and dry the bonding surfaces of the Funcosil test tube/test plate.
Remove any substances that could impair adhesion from the surface of the building material being tested. -
Preparations
Fix the test tube or test plate in position by placing butyl rubber between the contact surface of the tube and the surface of the building material.
-
-
Application
-
Conducting the measurement
- Fill the test tube with tap water up to the top graduation mark.
- Use the stopwatch to measure the amount of water that penetrates the building material in a period of e.g. 30 seconds, 1, 2, 3, 4, 5, 6, 10 and 15 minutes, and record the results.
- When a fill level of 3 ml is reached, refill the test tube. Record this water volume.
- Once the test is complete, carefully detach the test tube from the base using a filling knife.Refilling the test tube
.
When the level reaches 3 ml, refill the stand tube.
Record this amount of water.
After completion of the test, carefully remove the test tube from the substrate with a trowel.For detailed information regarding the application, please refer to the data sheet "Implementation Instructions".
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-