Tannin Stain Remover

Fully remove any existing old coatings.

Brush generously onto the discoloured area.

Repeat the process if necessary.

Wash off residue thoroughly with water.

Once fully dry, the wood can be treated with stains or paints.

Seal opened containers well and use contents as soon as possible.

When using on mineral substrates (plaster, masonry, concrete, etc.), set up a trial area beforehand to check the compatibility.

Soft jointing mortar can cause white efflorescence.

Components should be treated as thoroughly as possible.

Overcoating: after approx. 2.5 - 4 hours

Practice values at +20 °C and 65% relative humidity.

Low temperatures, poor ventilation and high humidity delay drying.

Ready to use

Brush

Clean tools immediately after use with water.

Ensure that any residue from cleaning is disposed of correctly.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

100 - 200 ml/m² depending on the discolouration intensity

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.