Article No. 606210

    PUR Primer S

    Solvent-based adhesion promoter

    Variant
    6062 | PUR Primer S
    Size / Quantity

    Brochures

    product.brochures.loading

    Product specifications

    On delivery

    Component A

    Density (20°C) 1.01 g/cm³
    Viscosity (25 °C) 20 mPa s

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use outdoors
    • Adhesion promoter in the system Remmers Deck OS 11a - II
    • Only suitable for outdoor applications

    Properties

    • Moisture-curing
    • Contains solvents
    • Single-component
    • Blue, translucent
    • Preparation
      • Substrate requirements

        A suitable substrate is PUR Color ZS in the Remmers OS 11a - II system.

        The substrate must be firm, dimensionally stable, capable of bearing loads and free of loose constituents, dust, oil, grease, rubber marks and other substances that could interfere with adhesion.

        The surface of PUR Color ZS must not be allowed to chalk or crackle.

        Surfaces that are more than 2 days old must be mechanically roughened and thoroughly cleaned before the adhesion promoter is applied.

        The substrate must be dry.

    • Working tools / cleaning
      • By brush / By roller
      • Microfibre roller, paintbrush, mixing equipment

      • More detailed information can be found in the Remmers Tool Programme.

        Clean tools and remove any contamination immediately after use and while fresh using Thinner V 103.

        Take suitable protective and waste disposal measures when cleaning.

    • Storage / shelf life
      • Store frost-free
      • Shelf-life 6 months
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 6 months.

    • Usage
      • Approx. 0.05 kg/m² (depending on the substrate)

    • Application examples
      • Roll coating

        Using a microfibre roller, apply a thin, even layer of adhesion promoter crosswise.

        approx. 0.05 kg/m²

    • General information
      • Unless otherwise specified, all of the values and application rates given above have been determined under laboratory conditions (20 °C) using standard colours. Slight deviations from these values may arise if the product is worked with on site.

        The product cures under the influence of humidity. If the layers are too thick, foam may form.

        Do not use on old (more than 2 days old) or superficially damaged surfaces (e.g. crackling or heavy chalking).

        The substrate must be protected against direct water loads before, during and after coating. If this is not done, the adhesion promoter must be applied again.

        Further notes on working, system construction and maintenance of the listed products can be found in the latest Technical Data Sheets and the Remmers system recommendations.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For professional users only!

        Further information concerning safety during transport, storage and handling as well as on disposal and ecology can be found in the latest Safety Data Sheet.