Crete FP

Suitable substrates: concrete and cementitious bonded screed only.

The substrate must be firm, dimensionally stable, capable of bearing loads and free of loose constituents, dust, oil, grease, rubber marks and other substances that could interfere with adhesion.

The tensile strength of the surface of the substrate must be at least 1.5 N/mm² on average (smallest individual value of at least 1.0 N/mm²), and the compressive strength must be at least 25 N/mm².

Prepare the substrate by suitable means, e.g. steel ball jetting or diamond grinding, so that it meets the requirements specified above.

Fill broken out or missing areas in the substrate with the Remmers PCC System flush with the surface.

Depending on the requirements of the system, make suitable anchoring cuts into the substrate.

As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.

Smoothing trowel

More detailed information can be found in the Remmers Tool Programme.

Clean tools, equipment and splashed material immediately while fresh with V 101.

Take suitable protective and waste disposal measures when cleaning.

If stored in unopened original containers, in a cool, dry place protected from frost: at least 6 months for component A, and at least 12 months for components B, C and D.

Pour all of the material onto the surface and immediately level off using a smoothing trowel. The surface pores of the substrate must be completely closed up.

Approx. 0.6 - 2 kg/m² binder (depending on the substrate)

Unless otherwise specified, all of the values and application rates given above have been determined under laboratory conditions (20 °C). Slight deviations from these values may arise if the product is worked with on site.

The resulting surface texture is strongly influenced by the conditions on site and the application method. Therefore, surface texture is not covered by product liability.

Even if the flooring is correctly installed, differences in colour, marks made during application, streaking and slight formation of pools cannot be excluded.

Due to the short reaction time, the coating operation must be well planned and prepared.

Excessively thick layers may cause bubbles to form.

Low thickness and low temperature can affect the visual effect of the finished surface.

Further notes on working, system construction and maintenance of the listed products can be found in the latest Technical Data Sheets and the Remmers system recommendations.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.