• BTM Universal

    Article No. 111710

    BTM [basic]

    Sprayable, universal release agent based on mineral oils

    Variant
    1117 | BTM
    Size / Quantity

    Discontinued product This container size is being phased out and is only available to a limited extent.

    Product specifications

    On delivery

    Density (20°C) 0.85 g/cm³
    Colour Yellowish
    Flash point > 100
    Consistency Liquid

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use indoors and outdoors
    • Absorbent and non-absorbent formwork substrates
    • Heated formwork up to +80 °C
    • Protective agent for concrete tables, production facilities and construction machinery

    Properties

    • Universal use with a wide range of formworks
    • Suitable for fair-faced concrete
    • Excellent release action, weather-resistant and non-damaging to the formwork
    • Application by brush or spraying
    • Solvent-free
    • Low odour
    • Preparation
      • Substrate requirements

        Clean any dirt or wax off the formwork.

      • Preparations

        Before using new wooden formwork for the first time, coat with a sufficient quantity of cement paste. Brush off the next day and treat with release agent.

    • Application
      • Application temperature: min. 5 °C max. 80 °C
      • By brush / By roller/ Low pressure spraying
      • Ready to use, straight from the container.

        Apply a thin layer of the material.

        Make sure that no pools form.

    • Working tools / cleaning
      • By brush / By roller/ Low pressure spraying
      • Clean tools immediately after use with V 101 Thinner.

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers
      • Shelf-life 24 months
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 24 months.

    • Usage
      • Depending on the application / m²
      • Dependent on application and formwork surface
        Non-absorbent formwork: approx. 1 l / 80 m²
        Absorbent formwork: approx. 1 l / 40 m²

    • General information
      • When using on fair-faced concrete surfaces according to the DBV (German Institute for Concrete) data sheet, set up a trial area depending on the fair-faced concrete class.

        Remove all material residue from the concrete surface before applying any coatings.

        Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.