Induline GLF-925 Glazing Bar Filler

The substrate must be clean, dry, free of dust, grease and loose substances, and prepared in the correct manner.

Compatibility with the materials used must be ensured. Please refer to the compatibility list.

Contact Remmers Technical Service if necessary.

Temperature of the material, air and substrate: from min. +5 °C to max. +35 °C

Cut off tip at an angle according to the width of the joint and inject, filling the joint completely.

Apply to the joint edges using sufficient pressure.

Manual and compressed-air gun

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

Approx. 25 ml/running metre for a 0.25 cm² joint cross-section

Insulating glass edge compound
Material compatibility has been tested according to ift Guideline DI-01/1: "The usability of sealants - Part 1 Testing of materials in contact with the edge-sealing of insulating glass units", version dated February 2008, Section 4.1 "Three-compound test" P1.
The following combinations are compatible with Induline GLF-925 Glazing Bar Filler:

Glazing packers
Material compatibility has been tested according to ift Guideline VE-05/1: "Proof of the compatibility of glazing blocks with cured sealants from the insulating glass edge-sealing", version dated November 2002.
Induline GLF 925 Glazing Bar Filler is compatible with standard commercial glazing packers based on polypropylene (PP).
For further information please contact the Remmers Technical Service.

Laminated safety glass
Material compatibility has been tested according to ift Guideline DI-02/1: "The usability of sealants - Part 2 Test of materials in contact with the edge of laminated glass and laminated safety glass", version dated 2009, Section 4.1 "Test methods when applying contact material to glazing rebate without UV radiation".
Induline GLF 925 Glazing Bar Filler is compatible with standard commercial PVB films.
For further information please contact the Remmers Technical Service.

Observe the regulations of Code of Practice No. 10 from the "Industrieverband Dichtstoffe" (Association of the Sealants Industry, IVD).

Not suitable for sealing glazing rebates.

Deviations from applicable regulations must be agreed separately.

The relevant test certificates must be observed when planning and carrying out work.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.