Article No. 4700776805

    PU Concrete & Floor Paint

    Polyurethane-reinforced floor coating

    Colour:
    light grey (approx. RAL 7035) | 7768
    Colour: light grey (approx. RAL 7035) | 7768
    Please choose a colour
    Size / Quantity

    Product specifications

    On delivery

    Density 1.1 g/m³
    Degree of gloss Silk matt

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on floors indoors
    • Sealing and coating concrete and cement screed surfaces
    • Living rooms & cellars, storage and utility rooms and other usable areas that are not exposed to constant water loads.
    • Covered outdoor areas

    Properties

    • Water-based
    • High-quality protective coating
    • Resistant to common household chemicals
    • 3 in 1: primer, coating and seal coat
    • Preparation
      • Substrate requirements

        The substrate must be clean, dry, stable, free of grease and capable of bearing a load.

      • Preparations

        Roughen smooth concrete surfaces before coating.

        Remove cement slurry.

    • Application
      • By brush / By roller
      • Application temperature: min. 8 °C max. 25 °C
      • Stir well before using.

         

        Applying a coating to concrete and cement, interior and exterior (covered outdoor areas):

        Prepare the substrate; wait until concrete and cement surfaces have fully set (approx. 4 weeks) before coating.

        Dilute the first coat with approx. 30% water.

        Then brush on 2 undiluted coats.

         

        Applying a coating on top of old coatings, or touching up a coating:

        Check that old coatings are compatible.
        Prepare the substrate, patch up any defects.
        Then apply at least 2 coats of undiluted PU Concrete & Floor Paint.

    • Application instructions
      • When coating continuous surfaces, only use materials with the same batch number as slight differences in colour, gloss and texture may occur.

        All connecting surfaces (railings, drains, door edges, etc.) must be thoroughly sealed. If this is not done, there is a risk of blistering and detachment.

      • Drying

        Low temperatures and high humidity delay drying.

    • Working tools / cleaning
      • By brush / By roller
      • Paintbrush, nylon roller with min. 10 mm pile height

        Clean tools, equipment and any splashed material immediately with water while still fresh.

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers
      • Shelf-life 24 months
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 24 months.

    • Usage
      • Approx. 160 ml/m² per coat, at least 2 coats required.
        Apply a trial coating on site to determine the precise application rate.

    • General information
      • Please secure the container against tipping over and leaking during transport!

        Not suitable for garage floors.

        Colour information and colour prints are non-binding. Colour deviations are possible depending on the substrate and printing technique. After drying, the final colour will differ from the fresh colour in the container.

        Do not allow water to pool.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.