Aqua RG-27 Renovation Primer

The substrate must be clean, dust-free and dry.

Dimensionally stable wood building elements: wood moisture content 11-15%

Wood building elements with limited or no dimensional stability: wood moisture content max. 18%

Thoroughly remove any dirt, grease and non-adhering old coatings.

Using a brass brush, thoroughly clean greyed and weathered wood surfaces to ensure optimum adhesion.

Remove any loose and torn knots as well as resin that bleeds from the wood and clean with a suitable product (e.g. V 101 Thinner).

Exterior wood that is to be protected against insects, blue stain and rot must first be treated with Aqua IG-15 Impregnation Primer IT* - this is not necessary for interior wood (*use biocides safely. Always read the label and product information before use).

Round off sharp edges.

Observe BFS Code of Practice No. 18 "Coatings on Wood and Wooden Working Materials in Outdoor Areas".

Temperature of the material, air and substrate: from min. +5 °C to max. +25 °C

Stir well.

Apply by brush.

Apply in the direction of the grain.

After drying, apply intermediate and final coats of medium-build or high-build stains.

Seal opened containers well and use contents as soon as possible.

Check colour and compatibility with the substrate by applying a trial coat.

Before coating technically modified woods and wood-based materials, apply the coating to a trial surface and conduct a suitability test on the desired area of use.

When renovating windows and exterior doors, we recommend an intermediate sanding step using sandpaper (P180) or a fine sanding sponge prior to further coating.

Dust-dry: approx. 1 hour
Overcoating: approx. 3 hours

Practice values at +20 °C and 65% relative humidity.

Low temperatures, poor ventilation and high humidity delay drying.

Ready to use

Paintbrush with acrylic bristles, flat brush

Clean tools immediately after use with water and detergent.

Ensure that any residue from cleaning is disposed of correctly.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 24 months.

Use the contents of open containers as quickly as possible.

Approx. 100 ml/m² depending on the absorbency of the wood.

Observe the regulations concerning design principles for wood protection.

Do not use on horizontal surfaces without drainage slopes and without edge radius, avoid accumulated moisture.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.