PUR Color Top OS

The substrate must be firm, dimensionally stable, capable of bearing loads and free of loose constituents, dust, oil, grease, rubber marks and other substances that could interfere with adhesion.

Suitable substrates are base layers in the Remmers Deck OS 11a - II system that have been blinded fully broadcast with quartz sand.

Add the entire quantity of the hardener (component B) to the base compound (component A).

Mix thoroughly with a slow-speed electric mixer
(approx. 300 - 400 rpm).

Pour the mixture into a separate container and mix again thoroughly.

Mix for at least 3 minutes.

Insufficient mixing is indicated by streaks forming.

Temperature of the material, air and substrate: from min. +10 °C to max. +30 °C.

As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.

Rubber wiper, epoxy roller, mixer

More detailed information can be found in the Remmers Tool Programme.

Clean tools, equipment and splashed material immediately while fresh with V 101.

Take suitable protective and waste disposal measures when cleaning.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

Approx. 0.5 - 0.8 kg/m² binder

Apply the material using a rubber wiper and then roll cross-wise with a suitable epoxy roller.

Make sure that no pools form.

To minimise streaking, roll over the surface again in one direction using a suitable large roller.

approx. 0.5 - 0.8 kg/m² binder

Unless otherwise specified, all of the values and application rates given above have been determined under laboratory conditions (20 °C). Slight deviations from these values may arise if the product is worked with on site.

When coating continuous surfaces, only use materials with the same batch number.

If dark or highly pigmented colours are used it is possible that, even with very careful application, shadows or light textures appear on the surface. This is due to the product system and does not in any way affect product suitability. In case of doubt set up a trial surface.

Suitable for vehicle traffic with rubber tyres; not suitable for vehicle loads with metal or polyamide tyres nor for dynamic point loads.

Abrasive mechanical loads leave traces of wear.

Observe the instructions for use of the corresponding Remmers Deck OS 11 systems.

Do not use in enclosed spaces.

Further notes on working, system construction and maintenance of the listed products can be found in the latest Technical Data Sheets and the Remmers system recommendations.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For professional users only!

Further information concerning safety during transport, storage and handling as well as on disposal and ecology can be found in the latest Safety Data Sheet.