• Impregnation Primer

    Article No. 064205

    Impregnation Primer

    Primer with hydrophobic effect

    0642 | Impregnation Primer
    Size / Quantity



    Product specifications

    On delivery

    Appearance Clear liquid
    Density (20°C) Approx. 0.8 g/cm³
    Flash point Approx. 22 °C
    Carrier material Alcohol – water-free (cannot be mixed with water)

    Once fully cured

    Once fully cured

    Alkali resistance Up to pH 14
    UV stability Very good
    Weather resistance Very good

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use outdoors
    • Absorbent mineral substrates


    • Solvent-based
    • Equalises absorption capacity
    • Alkali-resistant
    • Contains solvents
    • High penetration capacity
    • Preparation
      • Substrate requirements

        Dry, clean, free of dust and cracks (except hairline cracks) and capable of supporting a load.

        Free of salts known to be damaging to building materials.

    • Application
      • By brush / By roller/ Low pressure spraying
      • Application temperature: min. 5 °C max. 25 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +25 °C

      • Shake well before use.

        Apply evenly to the material using a brush, roller or spray.

        If needed, repeat the application.

    • Application instructions
      • Do not let excess material build up on the surface.

        Glossy layers must be avoided.

        Structural defects such as cracks, cracked joints, defective connections and rising damp must be remedied first.

        Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.

      • Drying

        Can be overcoated after 24 hours at +20 °C and 65% relative humidity.

        As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.

    • Working tools / cleaning
      • By brush / By roller/ Low pressure spraying
      • Brush, roller, surface brush, suitable spraying equipment

      • After use and before prolonged interruptions of work clean tools with Thinner V 101.

    • Storage / shelf life
      • Shelf-life 12 months
      • Store frost-free and cool / protect for moisture / close containers
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

    • Usage
      • Total application/absorption rate 200 ml - 400 ml Total / m²
      • Approx. 200 - 400 ml/m² depending on the substrate

      • Apply to a large enough trial area to determine the precise amount required.

    • General information
      • The relevant test certificates must be observed when planning and carrying out work.

        The current technical regulations must be observed.

        Deviations from applicable regulations must be agreed separately.

        Always set up a trial area/trial areas first.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.