Article No. 0568
BSP RZ Historic
Natural cement mortar
Product specifications
On delivery
Compressive strength
7 days: > 1 N/mm²
28 days: > 4 N/mm² (M 2.5)
28 days: > 4 N/mm² (M 2.5)
Dynamic E-modulus
Approx. 9000 N/mm²
Slump
Approx. 26 cm
Bulk density of fresh mortar
Approx. 2.2 kg/dm³
Maximum grain size
2 mm
Air void content
≤ 5 %
Water requirement
Approx. 15%, equal to 3.75 l/25 kg
Compressive strength class
CS III
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Interior and exterior use
- Mineral substrates in dry, damp, wet and underwater areas
- Filling joints and voids in historic buildings
Properties
- Historic binder from the 19th century
- Good flow properties
- Fast setting
- Slow development of strength
- Very good adhesion to the substrate
- This natural cement has been produced to the same formulation for more than 150 years and is also called Roman cement. It is based on a lime-marl from the Cretaceous period traditionally fired in a shaft kiln at low temperature.
-
Preparation
-
Substrate requirements
Clean, dust-free and capable of supporting a load.
-
Preparations
Pre-wet the substrate so that it is slightly moist.
Expose the grains close to the surface.
-
-
Application
-
Construct formwork if necessary.
Pour continuously from one side or corner.
Re-compact if necessary.
-
-
Application instructions
-
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
Protect wet mortar surfaces against frost, rain and drying out too quickly for at least 4 days.
-
-
Working tools / cleaning
-
Mixer, universal funnel, quick-snap fastener
-
Clean tools with water while the material is still fresh.
-
-
Storage / shelf life
-
Dry, in unopened containers, 6 months.
-
-
Usage
-
Approx. 1.9 kg/l void
-
-
General information
-
The mixing water must be of drinking water quality.
May contain traces of pyrite (iron sulphide).
Low chromate content in accordance with Directive 2003/53/EC.
The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-
Systemproducts
-
Historically protected / historically valuable buildings
Schools / universities / museums - München
- 2010
Die Fassade sollte saniert und erneuert werden. Vor der Hydrophobierung musste die Stabiliserung der Balkone erfolgen.
More information To the reference database
Show all