Article No. 108225
Mineral-based bonding layer
Downloads & documents
Product specifications
On delivery
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Interior and exterior use
- Bonding layer on mineral building material surfaces
Properties
- Plastic-modified
- High tensile adhesion strength
- Certified in accordance with DIN EN 1504-3
-
Preparation
-
Substrate requirements
Clean, dust-free and capable of supporting a load.
-
Preparations
Pre-wet the substrate so that it is slightly moist.
Expose the grains close to the surface.
The substrate must have an average pull-off strength of at least 1.5 N/mm²
-
-
Application
-
Application requirements
Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C
-
Apply the material to slightly damp surfaces.
Follow-up work must be carried out wet ond wet.
-
Application instructions
-
Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.
-
-
Working tools / cleaning
-
Mixer, trowel, wide brush, brush, grout broom
-
Clean tools with water while the material is still fresh.
-
Storage / shelf life
-
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
-
Usage
-
Approx. 1.1 kg/m² per coat
-
Apply to a large enough trial area to determine the precise amount required.
-
General information
-
The mixing water must be of drinking water quality.
The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.
Deviations from applicable regulations must be agreed separately.
The relevant test certificates must be observed when planning and carrying out work.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-