Article No. 578202

    Betofix K

    Mineral-based corrosion protection

    Colour: grey | 5782
    Size / Quantity

    Brochures

    product.brochures.loading

    Product specifications

    On delivery

    Maximum grain size 0.5 mm
    pH value > 12
    Bulk density 1.27 g/cm³
    Water requirement 17% corresponds to 0.34 l/2 kg

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on walls/ceilings indoors and outdoors
    • Interior and exterior use
    • Protects against corrosion

    Properties

    • Single-component
    • Mineral-based
    • Plastic-modified
    • Certified in accordance with DIN EN 1504-7
    • Preparation
      • Substrate requirements

        Clean, dust-free and capable of supporting a load.

      • Preparations

        Reinforcement:
        Degree of purity SA 2 ½ if applying corrosion protection, otherwise SA 2

    • Application
      • Brush
      • Application temperature: min. 5 °C max. 25 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. 5 °C to max. +30 °C

      • Full-coverage corrosion protection in two layers, minimum coating thickness 1 mm per layer

        Apply subsequent coatings (corrosion protection) after approx. 3 hours at 20 °C.

    • Application instructions
      • Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

        Apply spraying mortar Betofix SPCC TS after a minimum of 3 hours.

    • Working tools / cleaning
      • Brush
      • Mixing apparatus, brush

      • Clean tools with water while the material is still fresh.

        Any material that has already begun to dry can only be removed mechanically.

    • Storage / shelf life
      • Shelf-life 6 months
      • Store frost-free and cool / protect for moisture / close containers
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for 6 months.

    • Usage
      • Approx. 100 g/m reinforcing steel Ø 16 mm

    • General information
      • The mixing water must be of drinking water quality.

        The characteristic data of the product were determined under laboratory conditions at 20 °C and 50% relative humidity.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.

    Systemproducts